Lamination Processes

Hand Laid Glass Reinforced Polyester is still one of the most cost effective methods of manufacturing your composite or fibre glass mouldings, especially where low to medium volume and long term production are applicable. It has been the preferred method of production for many of our customers and we’ve been producing GRP mouldings in this way since inception 30 years ago.


This method is generally limited to the manufacture of fibreglass mouldings with relatively simple shapes that require only one face to have a smooth appearance (the other face being rough from the moulding operation). Norco GRP however are specialist GRP manufacturers of double finished surfaces and split GRP mouldings so if your part has 5 or 6 split sections for mould release necessity or is a complex form and shape, we can offer our many years of experience, knowledge and practical approach to produce your product utilising this cost-effective production method.

 

Resin Infusion

By drawing the resin through the stack of dry fibres under a vacuum bag you can achieve higher quality laminates than with traditional hand layup. The use of gelcoats and foam cores is still perfectly feasible and in some cases where the laminates are very thick the manufacturing time is quicker. It does require some planning at the design stage however and also some consideration on tooling as vacuum integrity of tooling is essential.

Benefits include improved consolidation, lower void content, reduced resin content and far better repeatability from part to part and it is more cost efficient than prepreg due to lower material costs. As it is a closed mould process, it virtually eliminates potentially harmful volatile organic compound (VOC) emissions and is also a very clean process. Hence the resultant mechanical properties of the cured part are markedly higher than would be the case with hand laminating, and part to part consistencies are greatly improved.

Resin Infusion Timelapse

Resin Transfer Moulding

This is broadly similar to infusion but instead of using a vacuum bag, the upper surface of the tool is produced using a solid GRP mould. This way you can achieve matched A and B surface finishes with tight control of finished dimensions, and rapid part production rates from a single mould as the injection process is much quicker. Careful tool design is required and it’s something that Norco can assist with. Generally, you would consider RTM for +100 parts due to the investment in tooling.

 

Williams Mould Shotv1
Williams Silicone Bagging354 Smaller
Silicone Bagging352 Small

 

enquirenowbutton

Contact Details

33 Holton Road
Holton Heath Industrial Estate
Holton Heath
Poole
BH16 6LT
Tel: 01202 623934
Email: info@norco.co.uk

facebook2     twitter1     youtube    linkedin

Contact Us

Sitemap | Terms & Conditions | Environmental Policy Statement

© Copyright 2017 Norco Ltd | All Rights Reserved | Built with HTML5 and CSS3

Made by The Collective Group